• Energy and cost-efficient transportation of minerals and tailings in the slurry form 

  Prasad, Vighnesh; Thareja, Prachi; Mehrotra, S. P. (2018-09-17)
• Growth of highly transparent single phase Ta-doped TiO2 films by RF magnetron sputtering 

  Manwani, Krishna; Panda, Emila (2018-06-18)
• Growth of ZnO/AZO bilayer: Effect of process parameters on the optoelectronic properties 

  Bandaru, Narendra; Panda, Emila (2018-06-18)
• Fabricating near UV transparent conductor by bandgap engineering 

  Dhawan, Rishi; Panda, Emila (2018-06-18)
• Annealing induced transformation and enhancement in the electronic defect states for AZO thin films 

  Bandaru, Narendra; Panda, Emila (2018-06-18)
• Processing of low grade iron ores and their effective usage for ironmaking 

  Mehrotra, S. P.; Singh, Ratnakar (12/11/2017)
• Surface immobilization Of Antimicrobial Peptide (AMP) for use in antibacterial coating 

  Majhi, Sasmita; Arora, Ankita; Mishra, Abhijit (2018-03-05)
• Synthesis Of lysine mimicking antibacterial polymers 

  Arora, Ankita; Majhi, Sasmita; Zheng, Wan; Liang, Hongjun; Mishra, Abhijit (2018-03-05)
• Immobilization of designed antimicrobial peptide for use in antibacterial surfaces 

  Majhi, Sasmita; Arora, Ankita; Mishra, Abhijit (2018-02)
• Surface immobilization Of antimicrobial peptide (AMP) for use in antibacterial coating 

  Majhi, Sasmita; Arora, Ankita; Mishra, Abhijit (American Physical Society, 2018-03-05)

  Bacterial colonization leading to biofilm formation on surfaces is a common threat to patient safety and health care units. One approach to address this prevailing problem is to develop antibacterial coatings on such ...
• Effect of anisotropy on stress-strain & pore pressure response of micaceous sand under undrained compression loading conditions 

  P., Seethalakshmi; Sachan, Ajanta (2017-12-14)
• Annealing induced electronic defect state transformation in Al-doped ZnO films 

  Bandaru, Narendra; Panda, Emila (Indian Institute of Technology Kanpur, 2017-01-02)
• Heat transfer and material flow numerical modeling for joining of dissimilar materials- Al 6061-T6 - AZ31 

  Singh, Amit Kumar; Sahlot, Pankaj; Arora, Amit (IIT kharagpur, 2016-11-05)
• Shape dependent optoelectronic properties of SnS powders through optical and scanning tunnelling spectroscopy 

  Singh, Chetan C.; Panda, Emila (Indian Institute of Technology Kharagpur, 2016-12-12)
• Experimental characterization of metal matrix composite with aluminium matrix and Molybdenum powders as reinforcement 

  Arora, Amit; Astarita, A.; Boccarusso, L.; Mahesh, V. P. (2016-09-07)

  This paper is on the successful fabrication of Metal Matrix Composite (MMC) using an Aluminium plate and Molybdenum powder by Friction Stir Process (FSP). The aim was to produce a superficial MMC layer on the Al plate in ...
• Developing self-disinfecting surface coatings using antimicrobial peptides 

  Majhi, Sasmita; Mishra, Abhijit (2016-12-11)
• Role of tip geometry in Conductive Atomic Force Microscopy for investigating nanoscale surface electrical properties of Al-doped ZnO films 

  Patel, Tvarit; Panda, Emila (2016-12-12)
• Influence of zinc interstitials and oxygen vacancies in carrier concentrations of Al doped ZnO thin films fabricated by sol-gel spin coating 

  Bandaru, Narendra; Panda, Emila (2016-12-12)
• Determination of bending limit curves for aluminium alloy AA6014-T4: an experimental approach 

  Saxena, Krishna Kumar; Mukhopadhyay, Jyoti; Das, Ipsita Madhumita (Springer verlag, 2016-02-14)

  The conventional forming limit curves as proposed by Keeler and Goodwin fail to evaluate formability in case of bending and hemming operations. This is due to the different failure mechanisms involved in biaxial forming ...
• Oxidation behavior of rare earth SmCo5 magnetic thin films 

  Bandaru, Narendra; Panda, Emila (Indian Institute of Technology Kharagpur, 2016-11-05)

View more